Operation with Lithium-Ion Battery Pack (Accessory)

Inserting/Replacing a Lithium-Ion Battery Pack

To switch from non-rechargeable batteries to a lithium-ion battery pack (6), remove the battery compartment cover (9) and the inserted non-rechargeable batteries.

Insert the lithium-ion battery pack (6) and let the locking mechanism (7) click into place.

To remove the lithium-ion battery pack (6), press the locking mechanism (7) and take the lithium-ion battery pack out of the measuring tool.

Charging a Lithium-Ion Battery Pack

Note: Lithium-ion rechargeable batteries are supplied partially charged according to international transport regulations. To ensure full rechargeable battery capacity, fully charge the rechargeable battery before using your tool for the first time.

If the lithium-ion battery pack is running low, the laser lines will flash slowly for approx. 1 min.
If the lithium-ion battery pack is empty, the laser lines will flash quickly for approx. 10 s, then the measuring tool will switch off.

Open the flap for the USB Type-C® port (5). Connect the USB port to a USB power supply unit using the USB cable (15). Connect the USB power supply unit to the mains supply.

Colour of charge indicator (4)

Meaning

Yellow

Lithium-ion battery pack is being charged.

Green

Lithium-ion battery pack is fully charged.

Red

Charging voltage or charging current is unsuitable.

Remove the USB cable (15) after completing the charging process. Close the flap for the USB Type-C® port (5) to protect it from dust and splashes.